產品中心
PRODUCTS
詳情介紹
僅供個人參考
HZ系列滑動閘門用于建材、冶金、礦山、電力、化工、玻璃、輕工、糧食等行業的庫頂、庫底及進出口等。是控制流量變化較大，啟動頻繁，切斷迅速的理想設備。
This valve is widely used at the top and bottom of store house and carrying port in metallurgical, mining, building material, food, chemical industries etc. It is the ideal equipment to control a great changing flow, to open and close frequently and to stop quickly.
結構特點：
Structure characteristic:
體腔內設灰斗卸料，避免物料沖擊體腔，延長了使用壽命，閘板運動由滑輪導向，減小了運動阻力，操作更加靈活、切斷快速，特別適用于各類微帶粘度的固體、粉料及小于Φ10mm的顆粒料，晶粒料的輸送及流量調節，安裝不受角度限制， 能隨時調節開度。該閥門有手輪和鏈輪兩種操作形式，I型為手輪，II為鏈輪。單向和雙向兩種結構形式，HZD為單向，HZS為雙向。
There is dust- ladle in body, which prevents body from impacting of material and prolongs the service life. The slide plate is guided by pulley, which reduces motive resistance. The valve is handy to operate, light in weight, non-obstructive and quick to stop. It is suitable to be used to carry all kinds of solid material of little viscosity, particle and crystal particle whose diameter is below 10mm and to adjust the flow. It can be installed at any angle. The position of its gate can be regulated at any time. This valve has two type of operation. One is manual wheel operation; the other is chain wheel operation. TypeⅠ means manual wheel. Type Ⅱ means chain wheel. The valve has two type of construction HZD is signal direction and HZS is double direction.
性能參數：
Performance parameter
|
使用溫度 Working temperature |
適用介質 Suitable medium |
|
≤300℃ |
粉料、顆粒料、晶體料等 Powder, grain and crystal material etc |
工作原理：
Working principle
主要由框架、閘板、絲桿、螺母等零件構成，人工轉動手輪使帶動絲桿螺母和閘板作水平方向往復運動，達到啟閉目的。閘板的運動像刀鍘一樣能切斷滯留在灰斗上的物料，達到密封狀態。
It is made up of frame, slide plate, screw bolt, nut etc. rotate the hand wheel to realize the horizontal reciprocating motion of nut and slide plate and the open-close of gate. The movement of slide plate is like that of hay cutter, which can cut off the material lagging on the dust-ladle and make the valve in sealed state.
HZ系列 外形連接尺寸：
Appearance joint dimension:
使用說明：
Usage explanation:
l 本閥可水平安裝或垂直安裝，安裝時兩法蘭連接中間必須加密封墊片，然后鎖緊螺栓。
l 操作時手輪順時針旋轉為閥關，反之為開，不得在手輪上再增加輔助杠桿。
l 若長期存放應使設備處于關閉狀態，各傳動部位應加潤滑油，不允許露天存放或堆置。
l It can be installed in horizontal or vertical. Sealing gasket must be put on the connected, then equably tight the bolt.
l You cannot add assistant lever to the hand wheel. Clockwise turn of hand wheel means the closing of valve, otherwise it means opening.
l The device should be in the shutdown if the valve-board is placed longer. Driving parts should add lubricated oil. Placing in the open and piling up is not permitted.
產品詢價
Online
Message
如果您對我公司有建議或反饋，請在此頁面填寫相關信息并提交，會有工作人員及時與您聯系， 或請直接撥打我們的電話。
